Like I don't have enough to do

[HOODLUM]

The dual cases are done!! I scored a set of 2x4 rock sliders. I did a side job of replacing a inner ie rod on a 01 Tacoma and as I was finishing up the guy asked me if I wanted some scrap steel.Since I enjoy messing around I said sure(I was figuring on some scrap plate and some tubing) He said he'd be back in a few minutes,So I finished bolting the wheel on and he walks up with a set of sliders that were built for his x-cab Taco. So all I have to do is cut of the existing mounts and re-do them.These will work out better because it will make it a lot easier to tie the exo-cage in.

[mytacoma]

Sounding good HOODLUM! Bring that sucker over here and let's go play!

[HOODLUM]

I wish.lol I still have quite a bit to do yet. I still have to mount the 63" chevy's in the rear then move the rears up front.Then mount the sliders and do the exo-cage.Then I can set up the propane equipment. And find a set of one ton axles.

[HOODLUM]

Well I haven't had time to do much lately. I did however score a set of Honda bucket seats(freebie) .Thanks to Jeff one of our Honda techs here where I work.Now I can get the bench seat out and cut the hole for the second t-case shifter. These seats have really good side bolsters and are very comfortable. I did cut the sliders to length but that was as far as I got.I'll let you know how the fitment goes for the seats.

[mytacoma]

Are you gonna be ready for the EC4RJ?

http://www.trdoffroad.com/forums/index.php/topic,1597.0.html

[HOODLUM]

Are you gonna be ready for the EC4RJ?

http://www.trdoffroad.com/forums/index.php/topic,1597.0.html

I should have it ready for the Jambo. If not only two things may not be finished and that would be the exo-cage and it running on propane. Either way I will be wheeling it at the Jambo.The above will just determine what trails I'll run.


BTW things "may" change if this deal I got going works out. I'll tell ya'll about the details later this month.

[EVILRoach]

Bring it down to ATL and I'll get you running on Pane. I have setup 10 trucks now on it and it's uber easy

[HOODLUM]

Bring it down to ATL and I'll get you running on Pane. I have setup 10 trucks now on it and it's uber easy

I just may take you up on that.Then we can go and test it out on the trails. I still have to get the vaporizer,fittings,lines and I'm not sure what else I need.(propane is completely new to me)I've never set up propane other than opening the bottle on the forklift at work.
Here's what I do have
mixer(250 I believe)
tank mounts,tanks

[EVILRoach]

You will need:
Mixer
Vaporizer
Regulator
Tanks
Lines

[HOODLUM]

You will need:
Mixer
Vaporizer
Regulator
Tanks
Lines

AHH I forgot about the regulator. Thanks
So I need to get the regulator,lines and the vaporizer.Well at least I have the most expensive part of the list covered.(the mixer)

btw EVILRoach it's good to see you around again. Thanks for your help